December 17, 2018
We are trying to complete the train signal challenge whereby one Edison detects a train, and another controls a boom gate. We are having difficulty getting the boom gate Edison to receive the signal and raise the boom gate. The signaling program appears to be working. We’ve installed a beep so that we know when the signal is sent and received. This is our boom gate program, would love some troubleshooting advice please.
August 24, 2015
I have had a little look at your program and I believe the issue is inside the forever loop. You have a ‘wait until IR message detected’ at the start and the end of the program. I believe that it may be fixed if you remove the one at the end. Because once at the end of the loop you will wait for an IR message then it will start the loop again and instantly look for another IR message before doing anything.