December 27, 2016
It’s impossible for me to programm Edison V2.0 with EdWare software (Online or downloaded)
I tried with 2 computers (Windows XP and Windows 8) with the example programs from EdBook2-robot-programs.
During download: the robot sounds a sound corresponding to the transfer of the data (style Modem) then a double Beep signs a correct transfer.
The memorization of the downloaded software does not seem to work.
August 24, 2015
Two beeps is the fail sound.
The download has not worked.
It sounds like there maybe some form of sound enhancements turned on. Can you confirm that ‘disable all enhancements’ is ticked as per the image here: https://meetedison.com/robot-activities/youre-a-robot-programmer/installing-edware/
If this is already the case, or the checkbox doesn’t exist, then there is likely some additional software causing the problem. Have a look in Control Panel for any other software application that suggests it’s used for sound settings. This could be called ‘Dell Sound’, ‘SRS Sound enhancement’, ‘HP Audio’, ‘DTS’, ‘Dolby’ etc. Open the software and look for any settings that suggest turning off sound enhancements. Turn off the enhancement and try programming Edison from the online app using the test program in menu/load/test programs.
Let me know if this solves the problem.
December 27, 2016
Hello, thank you for your answer.
Thanks to the forum and other information found on the net, I had already looked at all these points. I finally had to use a stereo sound interface in USB format and everything is ok now.
The main problem is the identification of the end transfer beep to know if the transfer is good or bad. In the case of a wrong transfer, the sound emitted does not correspond to the one given on this page https://meetedison.com/edison-robot-support/trouble-shooting/
This explains my bad interpretation of a good transfer. It would be in my opinion desirable to refresh the sound in case of bad transfer on your troubleshooting page.